Within the framework of its competence, the Labour Inspection Department of the Ministry of Labour and Social Insurance promoted the criminal prosecution of employers and company directors who violated the provisions of the legislation on occupational safety and health issues. As a result of these prosecutions, the Nicosia District Court sentenced in 2022 the following persons.200 for the following violations of the Minimum Safety and Health Standards (Use of Work Equipment at Work) Regulations, the Occupational Safety and Health (Notification of Accidents and Dangerous Occurrences) Regulations and the Management of Occupational Safety and Health Issues at Work Regulations that caused serious injury to its employee and endangered its employees and third persons:
(a) Failure to provide appropriate work equipment resulting in its employee, during the performance of his work while on scaffolding, falling to the floor from a height of approximately 1.8m and injuring himself.
(b) Failure to inform immediately, in the most expeditious and practical manner, the competent Provincial Labour Inspection Office of an accident that occurred to her employer which rendered him unable to perform his normal work for more than three days, excluding the day of the accident.
(c) Failure to ensure that there would not be any alteration of the scene of the accident in which her employee was injured after falling to the floor while on a 1.8m high scaffold.
[D] Failure to implement an appropriate safety system or risk management system which describes, inter alia, the arrangements for the effective planning, organisation, control and monitoring and review of preventive and protective measures to be taken for activities in the workplace which create hazards.
2. The company "AEROTECHNIKI ETERIA ZENIOS ZENIOU LTD" operating in the field of manufacturing of metal products and air ducts, to a total fine of €1.600 for the following violations of the Occupational Safety and Health (Notification of Accidents and Dangerous Occurrences) Regulations that caused the injury of one of its employees:
(a) Failure to send to the appropriate Provincial Labour Inspectorate Office a written notification of the accident by submitting a properly and fully completed approved notification form regarding an accident that occurred to its employee in the course of his work which rendered him unable to perform his work for more than three calendar days excluding the day of the accident.
Failure to ensure that there will not be any alteration of the scene where a notifiable accident occurred in which its employee was injured in the performance of his or her duties by the use of a scrubber.
3. The company "J.P. MULTIFORM STEEL LTD", which is active in the manufacture of formwork (moulds), to a total fine of €5.000 for the following infringements of the Safety and Health (Minimum Standards for Temporary or Mobile Construction Sites) Regulations, the Management of Safety and Health at Work Regulations and the Occupational Safety and Health at Work Acts which caused serious injury to one of its employees and endangered its employees:
[A](a) Failure to provide and maintain a safe method of work resulting in its employee who was engaged in manually moving a prefabricated mould for the construction of a capstone, walking on the slab formwork, falling from a height of approximately 4.33m and injuring himself.
Failure to provide employees with a safe working floor during the movement of a precast mold on an unfinished formwork floor.
[C] Failure to take the necessary measures to protect the safety and health of persons at work with respect to cooperation between employers in planning and organizing the performance of the work and interactions with operating activities at the site, in or near which the site had been established.
[D](d) Failure to take care to install suitable and sufficiently strong fencing or opening cover on the formwork floor.
[E) FAILURE TO PREPARE A WRITTEN ASSESSMENT OF THE RISKS TO THE SAFETY AND HEALTH OF ITS EMPLOYEES AND, BASED ON THAT ASSESSMENT, TO DETERMINE PREVENTIVE AND PROTECTIVE MEASURES TO ADDRESS THE RISKS.
4. The company "LOIS BUILDERS LTD "operating in the construction sector to a total fine of €5,000 for the following breaches of the Safety and Health (Minimum Standards for Temporary or Mobile Construction Sites) Regulations and the Occupational Safety and Health Acts that endangered its employees and other persons at work:
(a) Failure to provide persons at work and its employees with a safe working floor.
(b) Failure to schedule work at height for the construction of formwork and installation of prefabricated molds using appropriate equipment or collective protection mechanisms such as the use of appropriate scaffolding, handrails, work platforms or safety nets, or by providing adequate means of access and using fixtures or other anchored safety devices to prevent persons from falling.
(c) Failure to include in the safety and health plan (a) an analysis of working methods by phases (b) specific preventive and protective, technical and organisational measures for the performance of work at height, in particular for formwork construction work, and in particular the installation of prefabricated moulds for the construction of capitals and (c) other arrangements to ensure the safety and health of persons carrying out work at the site.
[D] Failure to take the necessary measures to protect the safety and health of persons at work with regard to cooperation between employers in planning and organizing the execution of work.
[E] Failure to maintain safe means of access to work areas for safe access.
5. The company "NICODEMOU & GAVRIAS CONSTRUCTION CO LTD" operating in the construction sector to a total fine of €1.000 for the following breach of the Safety and Health (Minimum Standards for Temporary or Mobile Construction Sites) Regulations which put its employees at risk:
[A](a) Failure to ensure that the Safety and Health Plan included the work of clearing and removal of materials.
6. "J.K.S. INTERIOR COMPOSITIONS LTD" a company engaged in the installation of plasterboards to a total fine of €2.100 for the following breaches of the Occupational Safety and Health (Notification of Accidents and Dangerous Occurrences) Regulations, the Occupational Safety and Health Acts and the Mandatory Employers' Liability Insurance Act which caused the injury to one of its employees:
(a) Failure to inform the relevant Provincial Labour Inspection Office of an accident that occurred to its employee in the most expeditious and practical manner.
(b) Failure to adequately supervise its employees resulting in its employee, while descending a portable ladder, having his right foot caught in the ladder and being injured.
[C] Failure to insure with any insurer against its liability for accident or occupational disease to any of its employees.
7. "CYLIFT & EQUIPMENT LTD" formerly "CYLIFT & EQUIPMENT LTD" engaged in the business of maintaining escalators to a total fine of €2.000 for the following violations of the Occupational Safety and Health Laws that endangered its employees:
(a) Failure to adequately instruct and supervise its employees.
(b) Failure to apply a safe work method in the process of maintenance of an escalator.
8. ALKIS H. HADJIKYRIACOS (FROU-FROU BISCUITS) PUBLIC LTD" operating in the field of production and packaging of food products to a total fine of €750 for the following violation of the Minimum Safety and Health Standards (Use of Work Equipment at Work) Regulations which endangered its employees and other persons:
(a) Failure to maintain suitable guards and to keep systems in operation that prevented access to or stopped the movement of hazardous items on packing machines before accessing the hazardous areas. Two machines were operating with open bumpers, one machine was operating without the bumpers, two machines did not have bumpers, and the bumper of one machine did not effectively cover its hazardous parts.
9. An employer operating in the construction sector to a total fine of €2,350 for violations of the provisions of the legislation on safety and health at work.
(OP/EHRP)
Contents of this article including associated images are owned by PIO
Views & opinions expressed are those of the author and/or PIO
Source