In relation to today's front page article of the newspaper "Politis" on the issue of asphalt concrete production plants, the Ministry of Agriculture, Rural Development and Environment notes the following:
- Following the strong protests of the residents of the Idali region for the deterioration of their quality of life and health from the operation of three asphalt concrete production plants in their area, the Council of Ministers appointed, on October 2, 2019, an inter-ministerial committee, consisting of the Minister of Agriculture, Rural Development and Environment, the Minister of Interior, the Minister of Energy, Trade and Industry, the Minister of Health and the Minister of Labour, Welfare and Social Insurance, to investigate the matter.
- Since then, an unprecedented, in terms of methodology and planning, process of investigating the issue and solving the problem began, which included correcting the incomplete legislative framework for the operation of asphalt concrete production units, obtaining expertise from a group of academic consultants, as well as cooperation and coordination of all relevant departments and services to manage the complex issue.
- The main conclusion of the inter-ministerial committee was that the factories in question had been installed in that area without the necessary Environmental Impact Assessment (EIA) having been carried out, as this was not provided for in the legislation at the time.
- On the basis of this conclusion, on the instructions of the relevant ministers, the Department of the Environment, in cooperation with the Department of Labour Inspection, prepared a strict legislative framework for the operation of plants of this type, which was approved by the Chamber of Deputies. According to this new legislative framework, asphalt concrete production plants are now included among the licensed plants and in order to operate they must obtain a permit for the emission of gaseous waste, through which the competent authority can impose the necessary operating conditions.
- The provisions of the new legislative framework now make it impossible to authorise asphalt concrete production plants in the Idali area, mainly because of the specific conditions relating to the altitude and meteorological conditions of the area and the proximity of the plants to residential areas. It was these data that created the problem in the area, a fact recognised by the group of academics who studied the issue of relocating these plants to other areas. It was the same data, together with the actual and repeated testimonies of the residents of the area, that persuaded the Court to order the suspension of the asphalt concrete plants in the area.
- In particular, in the area of Idali, where three asphalt plants are located around the perimeter of the residential area, the conditions of a possible PDP, as currently submitted to the competent authorities for such developments, could not be met if: (a) one unit is located less than 400 meters from the nearest residences; (b) the units are located at a significantly lower elevation than the residential area; and (c) the units are located in the direction of strong winds blowing toward the residential area at certain times of the year. A number of additional conditions would also violate the conditions required to submit such an EIR for the asphalt units to remain in the Idaho area.
- The Government's commitment from the outset was that bituminous concrete production units on new sites could only be licensed if it was ensured through the required studies that there would be no negative impact on the residents living nearest to those sites. The EIA for the installation of an asphalt concrete plant in the Mitseru area has demonstrated that, beyond any doubt, the operation of this plant under the strict conditions imposed will not result in any negative impact on the quality of life and health of the residents of the surrounding communities.
(NΓ/IK)
Contents of this article including associated images are owned by PIO
Views & opinions expressed are those of the author and/or PIO
Source